Need help?Do you have a question about the Target Audio TBA 260 and is the answer not in the manual?
General| Brand | Target Audio |
|---|---|
| Model | TBA 260 |
| Category | Subwoofer |
| Language | English |
Read the manual carefully and follow instructions for safe operation and to prevent hearing damage.
Maintain moderate volume while driving to hear external sounds and comply with sound regulations.
Entrust installation to qualified personnel for optimal performance and safety.
Coral Electronic is not liable for damages from improper use or manual non-compliance.
Terminals for connecting power supply (+12V, GND) and remote turn-on signal (REM).
Includes a protection fuse and a POWER LED indicating status (green/red).
Controls for low-pass filter (CROSSOVER), BASS BOOST, PHASE, and LEVEL.
Provides RCA (LINE IN) and High-Level (IN HILEVEL) inputs for audio sources.
Ensure the subwoofer does not interfere with driving and is in a well-ventilated area.
Mount on a solid surface, protected from dust, moisture, and moving objects.
Turn off the car radio, amplifier, and all electronic devices before connecting.
Connect RCA outputs from the radio to the subwoofer's LINE IN jacks.
Route signal cables away from power wires to prevent noise interference.
Use speaker outputs if RCA outputs are unavailable for connection.
Install a 30A fuse on the positive cable near the battery for short-circuit protection.
Connect power directly to the battery respecting polarity using 8mm² cables.
Connect the car radio's remote output to the subwoofer's REM terminal.
Route wires safely and double-check all connections before reconnecting power.
Protection circuits deactivate the subwoofer during faults, indicated by a red POWER LED.
Correct the cause of protection activation before restarting the amplifier.
Replace blown fuses with the same value to maintain warranty and prevent damage.
Set source off and volume to minimum, then play music at 3/4 volume for tuning.
Adjust LEVEL, CROSSOVER, and PHASE for optimal bass frequency balance.
Use BASS BOOST to increase low-frequency output by 6 or 12 dB around 75 Hz.
Adjust response by changing subwoofer position and emission direction for best results.
Optimal performance relies on correct installation, tuning, and system integration.
Features digital power supply and analog class AB amplifier for high performance.
Integrated amplifier reduces size and allows easy access to all controls.
High and low-level inputs ensure compatibility with all car radios.
Details speaker components like butyl rubber surround and titanium-plated cone.
Tuned exponential port minimizes air flux turbulence for improved bass response.
To Next Page