Target BK5SHLFXEB - Step 8: Installing the Back Panel

14
1. Make sure screws go through pre-drilled holes properly.
2. Do not over tighten screws.
step 8.
(H5) x 45
5/8’’ pan-head screw
Q
Q2
!
WARNING
Serious or fatal crushing injuries can occur
from furniture tip-over. To help prevent tip-
over:
- Install tip-over restraint provided.
- Place heavy items on lower shelves and as
far back as possible.
- Place heaviest items in the lowest drawers.
- Unless specifically designed to accommodate,
do not set TVs or other heavy objects on top of
this product.
- Never allow children to climb or hang on drawers,
doors, or shelves.
- Never open more than one drawer at a time.
(OR)
- Do not defeat or remove the drawer interlock system.
Use of tip-over restraints may only reduce,
but not eliminate, the risk of tip-over.
This is a permanent label. Do not remove.
hole for anti-tip strap
pre-drilled holes
pre-drilled
holes
Begin by installing all of the screws along one
edge of the back panel. Next, using a square
or tape measure, make sure that the cabinet is
square. (If using a tape measure, the distance
from one corner, diagonally to the other corner
should be the same in both directions.) Install
the remaining screws, starting with the corners.