Tascam TSR-8 - Page 30

Optional Equipment
en ne
RC-408 Remote Control Unit
The RC-408 has duplicates of the rehearsal/auto
punch-in and auto locator controls in addition to the
basic transport controls. Width is 212 mm (8-3/8), height
38mm (1-1/2), and depth 149mm (5-7/8). Cable
length is 5 m (15 ft.).
RM-408 Rack Mount Angle
Required when mounting the TSR-8 to a 19” rack
such as the TASCAM CS-607B.
RC-30P Remote Footswitch
MTS-30 MIDI-Tape Synchronizer
The MTS-30 allows the TSR-8 to sync-up with the
MIDI keyboards, drum machines, sequencers. Thanks
to its unique ‘Song Pointer Sync’ capability, the
associated MIDI equipment will stay in sync and follow
the tape no matter where you move the tape within a
given song. The MTS-30 responds also to the PITCH
CONTROL of the TSR-8. The maximum stability or
resolution of the synchronization is ensured by the use
of a newly developed, special error correction circuit.
32
MTS-1000 MIDiiZER
The MTS-1000 is a “Multi-Synchronizer’’ containing
a SMPTE tape transport synchronizer combined with a
MIDI-to-SMPTE synchronizer in a single low-cost unit.
It is used to make different machines — in this case tape
transports and sequencers or rhythm units — play at
exactly the same rate of speed, from any desired starting
point. This is called ‘‘chase-lock’’ capability. When the
MIDiiZER
is
connected
to
these
other
units,
it
be-
comes the all-in-one master controller for the system.
(Available Summer 1989.)
ES-50/ES-51 SMPTE Synchronizer/Controller
The TASCAM ES-50 can be used as either a stand
alone chase lock synchronizer or with the TASCAM
ES-51
edit
controller,
which
gives
access
to
more
com-
plex control/editing functions.