Tasco Telereader FXR-550 - Page 18

3) Hake sure that SYNC LED is blinking. After the above
procedure under good radio transmission condition, if
reception is started at the head of the data where
only the synchronization signal is transmitted, clear
picture can be obtained with the phase signal
synchronized and the rotation speed automatically set.
Cautions
If reception is started amid the video signals and much
black points are included in the video signals, phase
signal and video signals cannot be discriminated.
1) When automatic setting of the drum speed cannot be
made or, if made, it does not agree with the received
picture, set the drum speed manually with the r.p.m.
button.
2) When reception cannot be started or, if started, phase
bar is displayed on the screen, try as follows.
* If automatic start is not effected, make a forced
start with the START button.
* Remove the phase bar out of the screen across the
top or the bottom whichever the nearer, with the UP
or DOWN button.
3) To make the start of the transmitted picture agree
with the start of display screen, press the HOME
button at the start of the reception.
-16-