SAFE WORKING 11
ELECTRICAL STARTING SYSTEMS (Continued)
Never remove any electrical cable while the battery is connected in
the circuit.
Only disconnect the battery with the engine stopped and all switches
in the off position
Always ensure that cables are fitted to their correct terminal, a short
circuit or reversal of polarity will ruin diodes and transistors.
Never connect a battery into the system without checking that the
voltage and polarity are correct.
Never flash any connection to check the current flow.
Never experiment with any adjustments or repairs to the system.
Always disconnect battery and charge windings before commencing
any electric welding when a pole strap/earth lead is connected
directly or indirectly to the engine.
Batteries contain sulphuric acid, which can cause severe burns, if
acid is splashed onto the ski, eyes or clothes flush with copious
amounts of fresh water and seek immediate medical aid.
WARNING & ADVISORY DECALS
The following warning and advisory decals are applied to the
machine
‘CE’ Decal Wear Eye Protection read operators manual
To Next Page
Loading...