Tattile Vega1 Series - Removing a PIN Connection from the Power Supply Cable; Figure 13: Correct Backshell Mounting

 4PreparationandInstallation
RMM_00053_02 25 / 38 VEGA1 Series
6. Passthecabletroughttheadapter
7. InsertthePINsintothecorrectholesoftheconnector:
– A:GND
– B:GND
– C:+24Vdc
– D:+24Vdc
– M:Earth/ground
8. TightenadapterwithplugUTS6orreceptacleUTS1
9. Tightenthenuttorearof
eitherUTS1orUTS6
(recommendedtorquevaluestobeappliedaccordingprevioustable)
NOTICE!Improperuse!
RiskoflossIPprotectiondegreeandwaterinfiltration.
 Insertonly“one”cableintheNutoftheConnector.
 Ifmultipleconnectionsarerequired,useanexternaljunctionbox,becauseonlyonecablemust
beinsertedintotheconnector. 

 
Figure13: CorrectBackshellMounting

Importantadvices.
 ThejunctionboxandthecablethatconnectstheremotecameramustmaintaintheIPdegree
ofprotectionthatpreventstheentryofwater.
 ItisalsorecommendedtofixthejunctionboxatalowerheightoftheCameratoprevent
waterfrompouringintothecable.

 Theconnectorcableisreadyforuse.


4.4.2 Removing a PIN Connection from the Power Supply Cable
ThischaptershowshowtoeasilyremoveaPINconnectionfromthepowersupplycable.Theprocedure
isusefultomodifythecablingincaseoferrors.

 Thefollowinginstrumentationisrequired:
– SOURIAUMW‐RX20D44 extractiontool.
