Tattile Vega1 Series - Device check

 4PreparationandInstallation
RMM_00053_02 30 / 38 VEGA1 Series

4.5.4 Device check

Makesurethecameracomplieswiththefocusdistancedefinedduringtheprojectconfiguration.
Formoreinformation:
 Logintothewebinterface.
 OpentheDeviceInformationsection.
 CheckthevaluesspecifiedfortheChannelnbestfocusparameter.

6. CablethedeviceandconnectthedevicetoaPC.
7. Startupthedevice.
Afterabout60secondstheoperatingsystemisreadyforuse.
8. SearchforthedeviceusingthespecificcommandoftheTattilePathfinder.
9. Openthelivestreamofthedevicetocheckfor
thecorrectframing.
10. Ifneededadjustthedeviceorientationmovingthewall‐mountbracket.
11. Tightenthe4screwsofthewall‐mountbracketonthepole‐mountingadaptorwithatorqueof
10Nm.
 Thedeviceisreadyforuse.