Elasticated utility cloth (23) for covering the utility attach-
ment when cleaning upholstery and bedding.
Squeegee attachment (26) can be attached to the utility
attachment by inserting the hooks at the back of the squee-
gee attachment into the loops on the back of the utility
attachment, then secure the front of the utility attachment
into the locking clip on the top of the squeegee attachment.
Remove the squeegee after use by holding the locking clip
forward. The utility attachment should still be hooked into
the loops on the rear of the squeegee attachment, pivot
the utility attachment up and unhook from the loops to lift
it away.
The squeegee attachment is ideal for cleaning tiled or glass
areas such as windows or mirror panels. To clean win-
dows, start at the top, press the squeegee to the surface
and drag downwards in straight passes from top to bottom.
Wipe the rubber blade and the bottom edge of the window
dry after each pass. For small window panels, remove
the squeegee tool and spray the steam directly onto the
surface. Use the squeegee separately to wipe away the
moisture.
WARNING: Do not use on very cold glass, as the sudden
temperature change may crack the glass.
3.2.5. The water tank:
The metal ball weight (7)
The metal ball weight inside the water tank is attached
to the end of the suction hose. The ball is weighted and
designed to freely move around the water tank of the hand-
held steam cleaner (5). If the ball does get stuck outside
the water level, gently shake the product until it comes free.
The ball must remain in the water so steam can be gener-
ated whenever the steam trigger is pressed regardless of
the orientation of the handheld steam cleaner.
IMPORTANT: Do not add any detergents to the water/water
tank.
Rinsing the water tank.
Regularly rinse the water tank to release any deposits
that have collected on the bottom of the tank. Only use
deionised, demineralised or distilled water (available from
most large super markets) and fit the filler cap to allow
vigorous rinsing.
3.2.6. Using the hose:
To attach the hose to the handheld steam cleaner
After separating the handheld from the extension tube, at-
tach the extension hose by clicking the hose connector into
place. Then attach your chosen accessory onto the nozzle.
Switch off and unplug before attaching the hose.
After use, switch off, unplug and allow the hose and any
attachment to cool before disconnecting/ removing.
WARNING: In the event of the steam being blocked from
escaping, the steam pressure may be relieved via a vent
located under power cord bush. Never hold the product in
the area of the steam relief vent.
Steam or hot water may be emitted from this vent but only
if:
* The cleaning nozzle has been blocked, eg. by accidentally
sealing it against a surface.
* The boiler has become blocked due to
limescale caused by using hard water.
If steam is emitted from this vent, switch off, unplug and
allow the product to cool. Please contact the consumer
care for further advice.
WARNING: Never attempt to use a descaling agent in the
product.
3.3 After use:
3.3.1. Switch the cleaner off and unplug from the socket.
Place immediately on a suitable surface (eg. tiled floor)
where the residual heat/moisture in the floor nozzle/
cloth will not affect the surface or store the product as a
handheld steam cleaner (5) only. Wait until the cleaner has
cooled down completely.
3.3.2. Empty the water tank (9) by removing the filler cap
(11) and pouring out the water. Allow the inside of the
948030_IM.indd 7 5/15/2017 10:04:01 AM
To Next Page
Loading...
