- Separate the exhaust pipe from the air and
store it carefully.
- Put the appliance in a dry place.
- Remove the batteries from the remote control
and store them carefully.
ANOMALIES AND REPAIR
If any fault is detected, refer to the following
table:
Anomalies Causes Solutions
Product is not working No power supply
Water full indicator illuminate
Switch on device
Empty water tank
Start device after empty water
tank
Seems device is not working Indirect sunlight
Window or doors open
Filter is very dirty
Air inlet or air outlet is
blocked
Room temperature is lower
than the setting one
Close courtains
Close windows
Clean or change air lter
Clean container
Change temperature setting
Device noise too loud The unit is not put on a at
surface
Change device in a at surface
Compressor is not working Heat exceeded protection is
active
Restart the device after 3
minutes, when temperature is
lower
To Next Page
Loading...
Need help?
General
