- Fill the tank with water plus the anti-lime pro-
duct, leave about 30 minutes, drain and clean
with water
- Homemade solutions are not recommended in
the decaling of this appliance, such as the use of
vinegar.
How to clean the transducer:
- Put 5-10 drops of cleaning abluent on the surfa-
ce of the transducer, wait for 2-5 minutes.
- Brush off the scale from the surface.
- Rinse the transducer with clean water.
- Never use sharp or solid objects for cleaning the
transducer
How to clean the basin unit:
- Clean the water basin with soft cloth .if there is
excess lm on the surfaces, then soaks the cloth
with vinegar and repeat the process.
- If there is a lm in any of the depressions along
the basin ,drop a bit of vinegar into depression
and clean it out with a brush.
- Rinse the water basin with clean water.
Anomalies and repair
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
- If any anomaly is detected, check the following
table:
Anomalies Causes Solutions
Power lamp off or
does not work
Humidier is not plugged into
the power outlet or loose.
Connect power cord to electrical outlet and
press power button
Power lamp is on
but no mist
No water in water tank Fill water into water tank
Security switch is too loose Tighten the switch
The mist has a
strange odour
A New unit Take out water tank, open cover, let it stay
12 hours in cool position
It either has dirty water or the
water has been stagnant too
long
Clean water tank, ll with clear water
Power light is on,
but the machine
doesn’t work.
Too much water in the water
basin
Remove the water tank. Take a small cup
and remove some of the water from the
machine’s water basin. Reinsert the water
tank and make sure that it sits properly
The volume of spray
mist is too low
Too much mineral scale in the
water basin
Clean transducer
Water is too dirty or water kept
too long in the tank
Clean water tank and rell with clean water
Abnormal noise Vibration in the water tank be-
cause the water level too low
Fill the water tank
Machine is on and unstable
surface
Move the unit to a stable at surface
Spray mist is coming
out of the area
around the jets.
There are gaps between the
nozzle and water tank
Dip the nozzle in water for a while ,clean
it with a damp cloth and put it back to the
tank.
To Next Page
Loading...
