Taurus GRECO 16 - Page 8

ASSEMBLING THE BASE (DESK FAN):
-
appliance face down.
- Fit the base on the main body of the appliance.
- Fix the base using the screws provided (M).
- Stand the appliance up again so as to check
that the base works properly.
FITTING THE BASE FEET (CROSS BASE
STAND FAN):
- The appliance has anti-slip base feet (V) that
support the product.
- Position the base feet on the body of the
appliance.
- Position the base feet on the body of the
appliance using the screws (Fig.1).
FITTING THE BASE (ROUND BASE STAND
FAN):
- The appliance has anti-slip base (U) that sup-
port the product.
- To assemble the base, place the appliance
face down.
- Position the base feet on the body of the
appliance.
- Position the base on the body of the appliance
using the screws (Fig.2).
- Stand the appliance up again so as to check
that the base work properly.
ASSEMBLING THE GRILL AND THE
PROPELLER:
- Fit the rear grill (G) on the motor housing (I),
- Tight the grill nut (F) that attaches the grill,
Make sure of a correct setting.
- Fit the propeller (E) On the motor shaft (H).
- Tight the nut (D) that attaches the propeller,
Make sure of a correct setting.
- Fit the front grill (C) front the rear grill (G), mat-
ching the security screw position. Fix the front
the security screw (B) by using a screwdriver.
- Check the correct rotation of the propeller.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products’ packaging has
been removed.
USE:
- Unroll the cable completely before plugging it
in.
- Connect the appliance to the mains.
-
the desired direction.
- Turn the appliance on, by using one of the
speed selection buttons.
OSCILLATION FUNCTION:
- The oscillation function makes it possible to
automatically alternates over a range of 75º.
- To activate this function, press the (J) switch.
- To deactivate this function, follow the procedu-
re for switching it on in reverse.
HEIGHT ADJUSTMENT
- The appliance height can be adjusted, it’s just
necessary to unlock the knob (Q) place the
appliance at the desired height and lock again
the knob (Q).
CARRY HANDLE/S:
- This appliance has a handle on the upper part
of the body, which facilitates comfortable trans-
portation (Fig.3).
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Stop the appliance, selecting position 0 on the
selector control.
- Unplug the appliance from the mains.
- Clean the appliance.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.