EasyManuals Logo

Taurus Ikarus User Manual

Taurus Ikarus
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
and avoid direct contact with the
blades’ cutting edges.
- Recharge the battery/ies only with
the charger supplied by the manu-
facturer. A charger that is suitable
for one type of battery may cause
explosion or fire hazard when used
with other battery/ies.
Service:
- The appliance has been oiled in ori-
gin. In order to maintain the applian-
ce in a good operation conditions we
suggest greasing the blades every
time you clean it by putting a few
drops of oil on the ends of the blade,
and finally switching on the appliance
during a few seconds.
- Make sure that the appliance is
serviced only by specialist personnel,
and that only original spare parts
or accessories are used to replace
existing parts/accessories.
- Any misuse or failure to follow
the instructions for use renders the
guarantee and the manufacturer’s
liability null and void
Charging the battery
Caution: A new battery is not fully
charged and must therefore be char-
ged before the appliance is used for
the first time.
- Charge the battery at an atmosphe-
ric temperature of between 4 and
40ºC.
- Plug the charger (K) into the mains.
- Approximately 10-12 hours are
needed for a complete charge of the
battery. Never attempt to over charge
the battery (although it is recommen-
ded that the first charge of the battery
be of 14 hours in duration).
- Connect the charger (K) to the jack
using the socket on the appliance.
The socket is located at the lower/
back part of the appliance.
- The pilot light will come on to
indicate that the charger is charging
the battery.
- When the battery is charged dis-
connect the charger from the mains
supply.
NB: For a long battery life, it is
advisable to charge the battery, only,
when it has run out completely.
Instructions for use
Before use:
- Before using this product for the
first time, it is important to make a
full charge of batteries.
- Prepare the appliance according to
the function you wish to use:
Insertion of comb guide:
- Take the comb guide for both ends
and insert in the guidelines at the
sides of the appliance until it fits
properly (Fig.1).
- To extract the comb guide, just
pull out.
Use:
- The appliance can be used directly
connected to the mains, or by using
his batteries.
- Unroll the cable completely before
plugging it in.
- Ensure that the electronic connector
is properly attached to the appliance.
Manual Ikarus Premium.indb 18 16/01/2013 10:10:14

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Taurus Ikarus and is the answer not in the manual?

Taurus Ikarus Specifications

General IconGeneral
BrandTaurus
ModelIkarus
CategoryHair Clipper
LanguageEnglish

Related product manuals