PassWord
W&ĂĐƚŽƌZĞĂĐƟǀĞƉŽǁĞƌŐĞŶĞƌĂƟŽŶ
ĐŽƌƌĞĐƟŽŶĨĂĐƚŽƌ
Limiter ON
P.Factor 0.00 <<
Pic 8.29
Note:
Engineer Only.
We will set the param depends on the safety requirements, so customers don't
need to reset it. The password is same as 8.4 Running param
tŝŶĚdƵƌďŝŶĞǁŚĞŶĐŽŶŶĞĐƟŶŐǁŝŶĚƚƵƌďŝŶĞ
turn on this item.
Those parameters is used for setup wind
trubine MPPT curve.
8.5 Protect Param
WŝĐϴϯϬ
WŝĐϴϯϭtŝŶĚdƵƌďŝŶĞƐĞƚ
WindTurbine <<
OK Cancel
V1: 0.0V <<
0.0A
DC1->Wind OFF <<
DC2->Wind OFF <<
OK <<
Cancel
WŝĐϴϯϮWĂƐƐǁŽƌĚ
MPPT Num 0
WindTurbine <<