BATTERY’S CHARGE LEVEL:
- The load indicator (G) will turn
off the color when the appli-
ance id completely charged.
- NB: For a long battery life,
it is advisable to charge the
battery, only when it has run
out completely.
INSTRUCTIONS
FOR USE
BEFORE USE:
- Make sure that all products’
packaging has been removed.
- Before using this product for
the rst time, it is important to
make a full charge of batteries.
COMB GUIDE:
- The product comes with the
built-in comb.
- To change the cutting level,
press the measuring switch (I)
on the back of the product and
move upwards until you reach
the desired cutting position.
(Fig 1).
- To remove the guide comb,
press the measuring switch (I)
with your thumb and move it
upwards.
- To insert the guide comb (H),
place it following the guides.
(Fig. 2).
USE:
- The appliance can be used
directly connected to the mains
or by using his batteries.
- Unroll the cable completely
before plugging it in.
- Connect the appliance to the
mains.
- Make sure that the blades are
correctly aligned.
- Turn the appliance on, by
using the on/off switch.
- Select the desired cutting
height using the comb height
selector (I). Press it and adjust
the height according to the
desired cutting length.
ONCE YOU HAVE FINISHED
USING THE APPLIANCE:
- Stop the appliance using the
on/off switch
- Unplug the appliance from the
mains.
CLEANING:
- Disconnect the battery charger
from the mains and allow it to
cool before undertaking any
cleaning task.
- Dismantle the appliance fol-
lowing these steps:
- Remove the guide comb,
by pressing the measuring
switch (I) with your thumb
and move it upwards.
To Next Page
Loading...
General