Taylor c713 - Page 32

C713 Operator TrainingC713 Operator Training
30
C713 Operator TrainingC713 Operator Training
Most of the listed parts are included in the tune-up kit.
Three Months Parts Replacement
Refer to the Taylor Operator Manual or local Taylor Distributor for part numbers.
Note: For air cooled units, condensers should be cleaned monthly with a soft brush.
Design Cap
Every 3 months replace the following:
Drive Shaft Seal
Freezer Door
Gasket
Mix Feed Tube
O-Ring
Front Bearing Prime Plug
O-Ring
Scraper Blades
Draw Valve H-Ring
(Center)
Draw Valve
O-Ring