Section 6
6-1
Models 8752 and 8756 with Horizon® Pump
Operating Procedures
6
Operating Procedures
Model 8752 has been selected to show you the pictured
step-by-step operating procedures for both models
contained in this manual. These models, for all practical
purposes of operation, are the same.
The size of the freezing cylinder(s) is 3.4 qt. (3.2 L).
Model 8752 has one freezing cylinder, and Model 8756
has two freezing cylinders. Mix is stored in the lower front
refrigerated compartment and is pumped up to the
freezing cylinder by a Horizon
®
pump.
Duplicate the following procedures, where they apply, for
the second freezing cylinder on Model 8756.
We begin our instructions at the point where we enter the
store in the morning and find the parts laid out to air dry
from the previous night’s brush cleaning.
If you are disassembling the machine for the first time or
need information to get to this starting point in our
instructions, see
"Disassembly" on page 6-15.
Assembly
WARNING! Make sure the power switch is in
the OFF position. Failure to follow this instruction may
result in severe personal injury from hazardous moving
parts.
1. To install the driveshaft, lubricate the groove and
shaft portion that comes in contact with the bearing
on the beater driveshaft. Slide the seal over the shaft
and groove until it snaps into place. Do not lubricate
the hex end of the driveshaft. Fill the inside portion of
the seal with 1/4 in. (6 mm) more lubricant and evenly
lubricate the end of the seal that fits onto the rear
shell bearing.
Figure 6-1
2. Install the driveshaft through the rear shell bearing in
the freezing cylinder and engage the hex end firmly
into the gear box coupling. Be sure the driveshaft fits
into the drive coupling without binding.
Figure 6-2
WARNING! This machine has many sharp
edges that can cause severe injuries.
3. Before installing the beater assembly, check the
scraper blades for any signs of wear or damage. If a
scraper blade is nicked or worn, replace both blades.
11083
Apply the appropriate
Taylor approved food safe lubricant.
10156
To Next Page
Loading...
