TC Electronic TC 2290 User Manual

store this change and then jump to next preset (Using the <PRESET DOWN> key).
Assigning the keysequence
<SPEC><2><6><ENTER><0><ENTER> <PRESET><STORE> <PRESET DOWN>
to <KEY A> is done by the sequence:
Keynumber To make <KEY A> press:
<SPEC><4><0> <ENTER> <3><5> <ENTER> ;<SPEC>
<SPEC><4><1> <ENTER> <2> <ENTER> *<2>
<SPEC><4><2> <ENTER> <6> <ENTER> ;<6>
<SPEC><4><3> <ENTER> <1><1> <ENTER> -<ENTER>
<SPEC><4><4> <ENTER> <0> <ENTER> ;<0>
<SPEC><4><5> <ENTER> <1><1> <ENTER> -<ENTER>
<SPEC><4><6> <ENTER> <3><0> <ENTER> *<PRESET>
<SPEC><4><7> <ENTER> <3><4> <ENTER> ;<STORE>
<SPEC><4><8> <ENTER> <3><2> <ENTER> -<PRESET DOWN>
Now, starting from preset 99, each time <KEY A> is pressed the preset bypass method is chan-
ged and stored, and a jump to the next preset is made.
Please note that the factory presets 80-99 are store protected, this means that you'll have to
‘open’ first by setting <SPEC><8><ENTER><1><0><0><ENTER>. After you have changed
the
factory
presets
you
can
store-protect
the
factory
presets
again
by
pressing
<SPEC>
<8><ENTER><8><0><ENTER>.
We can make the above assign key programming even easier by using the ‘special number roll’
function.
Press: <SPEC> <2> <0> <ENTER> <1> <ENTER>. The above example of programming
<KEY A> is now done by the sequence:
Keynumber To make <KEY A> press:
<SPEC><4><0> <ENTER> <3><5> <ENTER> ;<SPEC>
; so we Started off as above, but now
; we can ‘roll’ to the successive spec.no
; values just by pressing <ENTER>:
<ENTER> <2> <ENTER?> ; <2>
<ENTER> <6> <ENTER?> ; <6>
<ENTER> <1><1> <ENTER> ; <ENTER>
<ENTER> <0> <ENTER> ; <0>
<ENTER> <1><1> <ENTER> ; <ENTER>
<ENTER> <3><0> <ENTER> ; <PRESET>
<ENTER> <3><4> <ENTER> ; <STORE>
<ENTER> <3><2> <ENTER> ; <PRESET DOWN>
Now to ’exit’ spec. roll press <> or <DELAY UP> once.
To check which keys <ASSIGN KEY A> is programmed for:
<SPEC><4><0><ENTER> ; shows value of first keycode
<ENTER> ; shows value of next keycode (spec.no.41)
<ENTER> ., shows value of next keycode (spec.no.42)
<ENTER> ; etc.
To remove ‘spec. number roll’ press: <SPEC> <2> <0> <ENTER> <0> <ENTER>.

TC Electronic TC 2290 Specifications

General

Brand	TC Electronic
Model	TC 2290
Category	Computer Hardware
Language	English