Factory Test & Alignment Specification For MS63F-LA Series (V0.10)
Page 10 of 18
2.4. SHOP-END Test
At final process stage, it’s necessary to perform “Reset shop” before any packing to leave
Factory mode and restore User default presets.
This function is accessible by selecting “Factory menu
SHOP init”, then pressing RCU “OK”
key. Other faster methods are available on above enclosed SIACP requirements (rev. v3.9).
Appendix n “How to upgrade SW FLASH using Mstar tool”
¾ Open Mstar “Mboot” software programming tool “ISP_Tool_4528”
¾ Click on “Read”,and select “mboot.bin”file
¾
¾ Then click “Connect”,it will check SPI FLASH’s tape----correct,it will display OK.
To Next Page
Loading...
