Swing the tank support bracket
into position against the van body
and mark the location of the hole.
Drill a 3/8” hole through the body
of the van at that location
Insert a 5/16”x1” bolt through
hole. Make sure to use a flat
washer under the bolt head.
Install a flat washer on the back,
and fasten with a locknut.
Now tighten the bolt holding the
tank guard.
Feed propane hose through the
hole you drilled earlier. Make
sure grommet is in place.
Remove the propane pressure
regulator and attach propane hose
to the swivel fitting.
Use two wrenches and tighten
securely.
Install pressure regulator, and
tighten securely.
The completed propane tank
installation
4
To Next Page
Loading...
