Teac LX Series User Manual

Installing LX-10/20 IEEE 1394 Version
2-4
Installing LX-10/20 IEEE 1394 Version
Overview of the LX-10/20 IEEE 1394 version installation is explained below.
Follow the installation procedures explained later on each operation system.
1. Attach the interface card to your PC.
2. Install the OHCI driver.
3. Install the LX Series device driver.
4. Install the LX Navi.
Installing Interface Card
Attach the PC card to your note PC
Insert the IEEE 1394 interface card CBFW3 to your PC card slot met the CardBus specification.
Check with your PC manual on the PC card slot information.
z You may not insert the IEEE 1394 interface card with other types of the PC card at a time.
z You may not install it to the upper slot.
z Be careful to insert it to your PC. The interface card or your PC may be damaged, if you enforce to
insert it.
Attach the PCI card to your desktop PC
Insert the PCI type interface card PCIFW3 to the PCI slot of your desktop PC.
Check with your PC manual on the PCI slot information.
z Replace a standard bracket to the supplied low profile one when installing the PCIFW3.
z Be careful to insert it to your PC. The interface card or your PC may be damaged, if you enforce to
insert it.

Teac LX Series Specifications

General

Brand	Teac
Model	LX Series
Category	Measuring Instruments
Language	English