ENGLISH
_
9
_
Troubleshooting
Problem Probable cause(s) Suggested remedy
Tape moves but no sound is heard. The volume control of the stereo amplifier Adjust the volume control to the desired
is set to its minimum position. level.
The input selector of the stereo amplifier Set to the "tape 1" position.
is not set to the "tape 1" position.
Strange tone quality or ragged sound. The noise-reduction switch is not set to Set the switch to the position corresponding
the correct position. to the setting used for recording.
Playback sound is unclear or wavering The heads are dirty. There is foreign Clean the heads as described in the
and clear recordings can't be made. material on the pinch rollers or capstans. section "Head Maintenance".
Before calling for service, check through the chart below for probable causes of the problems you experience while using this unit.
To Next Page
Loading...
Need help?
General
