2.1.8. Start WX Navi
After WX Navi starts, if you power off the WX-7000 recording unit or remove the cable, WX Navi
will display an error message and terminate. In such a case, if you turn the power back on or
reconnect the cable, and then restart WX Navi, the WX-7000 can again be recognized.
In the case of the WX-7000, if you power off the WX-7000 recording unit or remove the LAN cable,
not only will communications fail, but also the network will experience congestion in processing.
Make sure to close WX Navi first to detach the WX-7000 from the network. Do not power off the
WX-7000 before closing WX Navi. Do not power off the WX-7000 before closing WX Navi.
2.1.9. Do not put the PC into standby /sleep mode.
If the PC enters a standby/sleep/hibernation status while WX Navi is being used, communications
will cease, and a timeout will cause a disconnection.Please ensure not to make setting of standby,
sleep, hibernation status on Windows Settings of Power Options while WX Navi is being used.
Please be noted that the settings of standby or sleep status might have been selected as a default
setting right after purchasing especially for notebook PC.
2.1.10. Please do not operate the computer background tasks
While Windows Update, scan disk, defrag, Indexing Service, Super Fetch and other tasks is
running, processing power of the computer is reduced, you may record at a high sampling rate
cannot be maintained. Set your PC so that these features do not work.
Also, please set so as not to run the scheduled task and the other tasks, such as reducing the
processing power of the PC.
Please consult your administrator of the computer for the detail.
To Next Page
Loading...
Need help?
General
