50 OWNER’S MANUAL
INSTALLING THE REAR WHEEL
Installation is the reverse procedure of removing
the rear wheel. NOTE: Make sure that the chain is
on the small cog as you position the rear wheel in
the dropouts.
Check that you have the correct clamping
pressure (Quick Release Lever).
If you have axle nuts make sure they are tightened
correctly.
Ensure that the Quick Release Lever is positioned
as shown to prevent the lever from releasing
whilst riding.
When repositioning the wheel in the frame
make sure that it is centrally located to prevent
‘rubbing’ of the wheel on the frame.
WARNING
Failure to properly
reinstall a wheel may
result in a crash.
To Next Page
Loading...
