The push rod fits in to the centre of the axle.
Confirm that the selector is locked in to 2
gear.
The Thick yellow line must sit between the two thin white
lines when in 2
nd
gear. This will correctly align the 3
gears.
Insert head stem and partially tighten. Final up / down
adjustment can be completed later when Transporter at
ground level or when final adjustment pre-test riding.
Check the tightness of the cranks with 8mm Hex key.
Fit the Pedals.
Pay attention to the pedals. They are marked left and
right (L R). Please note that the Left Hand Pedal has a
Left Hand Thread (Counter-clockwise)
To Next Page
Loading...
