11
Safety, warnings and troubleshooting information
• Follow all safety instructions provided when used with any TEC products.
• Do not operate the gauge if any liquid gets inside the gauge.
• If the inside of the gauge gets wet, immediately turn off the gauge and remove the
batteries.
• Leave the battery compartment cover off to allow for drying.
• Dry the batteries with a towel and allow the batteries to air dry for at least 12 hours.
• Allow the gauge to air dry for at least 12 hours before inserting the batteries and
powering back on.
• If a liquid gets inside the pressure ports, contact TEC at 612-827-1117.
• Do not attempt to dry any of the electrical connectors with a Q-Tip or similar item.
Lithium Ion battery safety and warnings
• Do not leave the batteries in direct sunlight or in an area heated by sunlight. The
battery could generate heat, smoke or ames.
• Do not use the batteries when there is rust present, the batteries have a bad smell
or if the batteries are damaged in any other way.
• Keep the batteries out of the reach of children and animals.
• If uid from the battery leaks out and makes contact with skin, wash with soap
and water. The uid may cause irritation. If that happens please see a doctor
immediately.
• Do not expose the batteries to extreme heat, ames or liquids.
• Do not modify or disassemble the batteries as this could result in leakage or
explosion.
• When replacing the batteries in the gauge, use identical, fresh batteries.
• Always charge both batteries at the same time.
Touch screen use and care
• A screen protector is included with the DG-1000. Replacement screen protectors
can be purchased from TEC.
• To clean the screen, use the microber cloth included with the DG-1000.
• Do not clean the screen with ux, water, acetone, ethanol, isopropyl alcohol,
toluene or ammonia (glass cleaner).
Introduction
The DG-1000 is a two channel low pressure gauge that is intended to be used with
equipment manufactured by The Energy Conservatory, or as a manometer.
To Next Page
Loading...
