14
Model: TX-256 Article No. 5088, 12/2023
FAQs
Important information
⚫ Do not submerse the unit in water. Although the unit is waterproof and
dust resistant to IP66 ratting, it is not intended for use under water.
⚫ Don’t forget your password. It is not necessary to set a password, but if
you do set it and forget it, refer to the FAQ → Q4 to reset the device to
factory setting.
⚫ Remember to clear the SD card before each venture. If the SD card fills
up, the unit will stop recording.
⚫ Keep the SD card away from strong electromagnetic or magnetic fields
such as a speaker or TV receiver.
⚫ Batteries do not last forever. Keep an eye on the Low Battery symbol. If
the batteries die, you may not get that perfect shot you were hoping for.
Q1: The camera does not turn on
A1: Switch the device OFF. Remove all batteries and the memory card.
Leave the device for a few minutes. Reinsert the memory card followed by
new batteries. Switch to TEST mode.
Q2: Files not saving to the SD card
A2: When the memory card is recognized by the device, the memory card
icon will be displayed on the screen in Test mode. If the card icon is not
displayed, power OFF the device and remove the memory card. Carefully
reinsert the memory card and switch to TEST mode. If the card icon does
not display, navigate to the Format option to format the card. After
formatting the card, power OFF and remove the card. Then reinsert the
card.
If the card is not recognized after formatting, remove the card and format
the card in a PC or card reader connected to a PC. After PC formatting
reinsert the card into the camera. If the card is still not recognized, the
card may be incompatible with the camera and may need to be replaced.
Note: Performance of a memory card will degrade over time. In the event
of reduced or unexplained poor performance, firstly reformat the card. If
reduced performance remains, the card will need to be replaced with a
new micro-SD card.
To Next Page
Loading...
Need help?
General