1.Power Supply: Only use the power cord provided with the unit to power the unit. When connecting and
disconnecting the power cord, be sure the power of the unit is off. Connect the cord to the rear of the unit and
then connect it to the outlet.
2.Voltage selector: Select between 230V AC 50Hz / 115V AC 65Hz. When using with a 115V outlet, the unit
should be set to 115V.
3.FM & AM Antenna: Connect your FM and AM antennas here.
4.SUB Outputs: Connect the sub output to either a recording device, another amplifier or a powered (active)
subwoofer.The signal from the line output is a passive output and cannot be connected directly to a passive
speaker.
5.Pre Output:Connect the line output to either a recording device or another amplifier. The signal from the line
output is a passive output and can not be connected directly to a passive speaker.
6.REC LINE Output: Connect the REC line output to a recording device. The signal from the line output is a
passive output and cannot be connected directly to a passive speaker.
7.DVD Input: Connect any stereo signal output such as a DVD, CD, TAPE, Mixer etc to this input. To play a
signal connected to this input make sure the DVD input is selected on the front panel.
8.CD Input: Connect any stereo signal output such as a DVD, CD, TAPE, Mixer etc to this input. To play a signal
connected to this input make sure the VCD/CD input is selected on the front panel.
9.Speaker Output Sets: Connect the passive speakers to these six groups of output sets. Press the selectors
on the front panel to select the output speakers. It is recommended to use 8 ohm speakers only.
To Next Page
Loading...
Need help?
General
