Page 3 of 5
• In case of a storm, it is recommended that you unplug the decoder from the mains and from the other connected devices (TV set,
antenna, SPDIF and Ethernet devices).
• Leave the mains socket accessible so that you can unplug the set quickly. The power supply unit serves as disconnect device. Be
sure that the mains supply socket outlet you use is easily accessible and located as close to the product as possible. The power
connections to the product and the mains supply socket outlet socket must be accessible at all times, so that you always can disconnect
the product quickly and safely from the mains supply.
Connecting to the mains supply
• This equipment is designed to operate at 100-240V AC, 50/60Hz.
• If you are in any doubt about the mains plug or connection, please consult the Customer Service.
• Only the power adapter supplied with the decoder must be used.
Remote Control Unit
Your remote control is specifically designed to be used with your decoder and it requires some specific batteries (See the chapter Technical
Specifications). Insert batteries correctly. There may be a risk of explosion if the batteries are incorrectly inserted. Do not attempt to
recharge disposable or non-reusable batteries.
The batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. The batteries
use some hazardous substances which are very polluting for the environment. Do not throw them out. Remember to dump them in collection
points.
Technical Specifications
To Next Page
Loading...
Need help?
General