Please check and identify the supplied
accessories
_'_ AC power supply cord
flung thick type) (SJA172).................................................2 pcs.
[-7 AC power supply cords
(short thin type) .................................................................. 3 pcs.
[] Stereo connection cables
(R_B08) .....................................................................6pc_
] FM indoor antenna
(RSA0006)..............................................................................1 pc.
[] AM loop antenna set (RSA0010)
AM loop antenna .................................................................1 pc.
AM loop antenna holder.....................................................1pc.
Screw .....................................................................................1pc.
] Remote control transmitter
(RAK-SA607MH) ................................................................. 1 pc.
[] Batteries .............................................................................. _ pcs.
_ZD
EZD
[] Notebook-like binder [Liner notes organizer]
(RFA0623-K1) ....................................................................... 1 pc.
[] Adhesive number
(RQLA0326) .......................................................................... 1 pc.
Use numbers indicated in parentheses when asking for replacement
pai_s.
To order accessories call MSC Accessory Dept. 1-8(D-332-5368.
CAUTION:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged.to try to correct
the interference by one of the fonowingmeasures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
froth that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
FCC Notice: This system complies with new Part 15, except for
the radio receiver, which complies with old Part 15, Subpart C
of the FCC Rules. Operation is subject to the following two
conditions: (1) This dewce may not cause harmful mterference,
and (2) this device must accept any interference received,
including interfenmce that may cause undesirable operation.
The radio receiver is not subject to above item (2).
Any unauthorized changes or modifications to this equipment
would void the user's authority to operate this device.
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR PRODUCT DAMAGE, DO NOT
EXPOSE THIS APPLIANCE TO RAIN,
SPLASHING, DRIPPING OR MOISTURE.
CAUTION:TO REDUCE THE RISKOF ELECTRIC
SHOCK,DO NOTREMOVESCREWS.
NO USER-SERVICEABLEPARTS
INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
_1_ The lightning flash with arrowhead symbol, within
• • • - an equilateral triangle, is intended to alert the user
• _ to the presence of uninsulated "dangerous voltage"
mid _ within the product's enclosure thaLl_y I;u_.f suffi-
cientmagnitude to constitute a risk of elec_c shock
to persons. _
The exclamation point within an equilateral triangle
is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the ap-
pliance.
Ii
To Next Page
Loading...
