DOt.BYNR
REVERSE
MODE
%
Both sides of the tape in Deck 1 will be played, followed by both
sides of the tape in Deck 2. (Repeated up to eight times.)
JPreparation I
Load the tapes to be played into Deck ] and Deck 2.
Note that for series playback it is not possible to select different
types of Dolby NR for Deck 1 and Deck 2. It is recommended that
you use two tapes which were recorded using the same type of
Dolby N-R (or both recorded without Dolby NR).
H Press DOLBY NR to listen to tapes recorded by
Dolby B-type noiss-reduction ..........
B
E!
El
Press REVERSE MODE to select the" _ "mode.
Press DECK 1/2 to select the Deck 1.
Press !,.
Series playback will begin from the forward side of the tape
in Deck 1.
For your reference:
It is also possible to begin series playback from the reverse side of
the tape in Deck 1 or from Deck 2. (Refer to "Reverse function"on
page 31.)
To Next Page
Loading...
