Technics SX-KN400

Part Ill
Advanced applications
Storage capacity
Expressed
in
terms
of
notes,
the
total
storage
capacity
of
the
SEQUENCER
is
approximately
1600 notes.
« Data such as sound changes etc. can be stored
for each part, but will reduce the storage
capacity accordingly.
Recording and playback
How to count the number of notes
The
cycle
of
one
key
being
pressed
and
released
is
counted
as
one
note.
When
the
remaining
storage
capacity
becomes
20%
or
less,
it
is
shown
as
a
percentage
(%)
on
the
display.
When
“0”
is
shown
on
the
display
and
the
“beep,
beep,
beep”
error
message
sounds,
no
more
data
can
be
stored
in
the
SEQUENCER.
The
tempo
can
be
freely
adjusted
during
playback.
Therefore,
you
may
record
the
per-
formance
by
playing
the
keyboard
slowly.
If
new
songs
are
stored
over
songs
already
stored,
the
previously
stored
songs
are
erased.
Storing
two
or
more
parts
at
the
same
time
By setting up the SEQUENCER to record multiple
tracks, you can perform and record multiple parts
at one time.
(KN400)
SEQUENCER
STEP ACCOMP/
RECORD RECORD POLY1 POLY2 CHORD
Oo ce) 1@) O (@)
CC Ge)
1. Set the beginning sounds and effects before
starting to play.
2. Press the RECORD button in the SEQUEN-
CER section. Its indicator lights.
RECORD
O
=
3.
Press the SEQUENCER buttons for the parts
you wish to store. The indicators flash slowly.
(KN400)
ACCOMP/
POLY1 POLY2 CHORD
oO oO
O
CG)
. Play.
B)
Keyboard sounds are produced according to
the CONDUCTOR settings.
KN400: When storing the POLY 1 or POLY
2 part, select the respective part on the CON-
DUCTOR before selecting the sound.
When recording the ACCOMP/CHORD track
during multiple-track recording, be sure to
turn on the ONE-FINGER or FINGERED but-
ton of the AUTO PLAY CHORD before storing
chords.
KN400: When recording both the POLY 2 and
ACCOMP/CHORD tracks, turn off the AC-
COMP PART 2 and 3 buttons.
. When you have finished playing, press the
RECORD buiton to turn it off.
RECORD
oO
ce)
IM—-OzmM