Technics SX-KN650 - Getting Started

a)
Cc
°°
2:
(om
( age
3
Sees:
2)
a
©
oO
Getting started
Before you play
This Keyboard can use either dry cell batteries or ordinary household AC current. If using bat-
teries,
use
six
R20/LR20
batteries
(“D”
size,
UM-1).
To
use
AC
current,
an
SY-AD6
AC
adaptor
(12V,
2A)
is
required.
(Note:
Use
of
an
AC
adaptor
other
than
the
SY-AD6
may
cause
damage
to your instrument.)
e The batteries or the AC adaptor is an included accessory (depending on the country where
sold).
e
The
output
power
differs
depending
on
whether
the
AC
adaptor
or
batteries
are
being
used.
When using batteries
Open the battery compartment
cover, found on the rear of the in-
strument. Insert six R20/LR20 bat-
teries, and replace the battery
compartment cover.
e To insert the batteries correctly,
follow the + and — polarity indica-
tions.
e Do not use new and old batteries
together.
e Remove the batteries from the
battery compartment and store
separately when the instrument
is not to be used for a long time.
When using the AC adaptor
Connect the AC adaptor.
e Do not disconnect and connect
the AC adaptor when the PLAY
button is on.
Music stand
Affix the music stand as shown.
e Even when batteries are installed, if the
AC adaptor is used, the battery circuit is
bypassed and the power is supplied
through the AC adaptor.
e When batteries are used, if the instrument
is left on but the controls are not touched
for a while (about 5 minutes), the energy-
saving function is activated and the PLAY
button turns off automatically.
e When the power is withdrawn from this in-
strument, the various storable memories
and storable function settings of this instru-
ment will be erased in about 10 minutes.
e When battery power is low during a per-
formance, Att (KN550) or “WARN-
iNG!! Low Batteries” (KN650) is shown
on the display. In this case, replace the
batteries as soon as possible.