Phenomenon Remedy
COMPOSER
Storage is not possible. • The remaining memory capacity of the COMPOSER
is 0.
Setting the time signature is not possible. • The time signature cannot be changed for a pattern
which is currently recorded in the COMPOSER. If you
wish to change the time signature, first follow the
procedure to clear the memory.
The playback timing of the rhythm pattern is
different from the timing with which it was recorded.
• The QUANTIZE function was on when the pattern was
recorded and the timing was automatically corrected.
Set the quantize level to a smaller note unit or to OFF
when recording.
Disk Drive
The Disk Drive produces a noise during recording
or playback.
• This occurs when the Disk Drive is reading a disk. It
does not indicate a problem.
When the procedure to load from a disk is per-
formed, the contents of the keyboard memory are
erased.
• When performing the load operation from a disk, the
keyboard memory changes to that of the data loaded
from the disk. If you wish to preserve a song which is
stored in the keyboard memory, save it on a disk
before performing the load procedure.
MIDI
Data cannot be exchanged through MIDI terminals. • The switch for the COMPUTER terminal is not set to
MIDI. Turn off the power to this instrument and set
the switch to MIDI.
• Match the channels on the transmitting side and the
receiving side.
The sound quavers or is distorted. • When the COMPUTER terminal or both the MIDI IN
and OUT terminals are connected to a computer,
depending on the computer software the received data
may be sent back to the instrument just as it is.
Because of this the sound generated from the keys
and the sound generated from the returned data are
both produced, causing undesirable effects, such as
the sounds canceling each other out, for example. In
this case, either change the software settings to
prevent received data from being returned, or set the
MIDI LOCAL CONTROL to off.
Other
Noise from a radio or TV can be heard. • This sometimes occurs when electrical equipment
such as a radio or TV is used near the instrument. Try
moving such electrical equipment further away from
the instrument.
• The sound may be coming from a nearby broadcast
station or amateur radio station. If the sound is
bothersome, consult your dealer or service center.
The cabinet becomes warm during use. • This instrument has a built-in power source that heats
the cabinet to some degree. This is not an indication
of trouble.
180
QQTG0617
To Next Page
Loading...