Technics SX-KN930

SYMPTOMS WHICH APPEAR TO BE SIGNS OF TROUBLE
The following changes in performance may occur in the Technics Keyboard but do not indicate trouble.
The butions, keys, etc. malfunction. ¢Turn off the PLAY button once, then turn it on again. If
this procedure is not successful, turn off this button
once. Then, while pressing the three buttons to the
right of the display, (TRANSPOSE A and V , and
EXIT) at the same time, turn the PLAY button on
again. (Note that, in this case, all programmable
seitings, functions and memories return to their
factory-preset status.)
No sound is produced when ithe keys are pressed. | «The MAIN VOLUME is at the minimum setting. Adjust
the volume with the MAIN VOLUME corirol.
eThe volumes for the selected parts are set to the
minimum levels. Use the balance buttons to set the
volumes of the relevant parts to appropriate levels.
¢The part is muted.
eThe local contro! for a part performed on the keyboard
is set to OFF. Set the local control to ON.
Only percussive instrument sounds are produced | eA sound in the KEYBOARD PERC sound group is
when the keyboard is played. selected.
Sounds and effects
The volume is very low when ithe keyboard is |e¢The volume setting in the SEQUENCER contents is
played. very low. Follow the INITIAL procedure to reset the
settings.
Some sounds cannot be selected. eWhen the GENERAL MIDI status is set to on, the
sounds which can be selected and operation which can
be executed are limited. Turn the GENERAL MIDI
status off to return the instrument to its normal
operation.
pou
a
ww
The sound you hear is different from the sound jeThis sometimes occurs when you play back
you selected. SEQUENCER or COMPOSER data which was created
on a different model, or when MID! data is received
from a connected instrument. Select the desired
sounds again.
q
The rhythm does not start. ¢The DRUMS volume is set to the minimum level. Use
the balance buttons to set the DRUMS volume to an
appropriate level.
eA rhythm in memory with no stored pattern was
selected. Select a different rhythm.
eA SEQUENCER PLAY button is on. when you are not
playing back the SEQUENCER performance, turn off
the SEQUENCER PLAY button.
¢Clock is set to MIDI. Set CLOCK to INTERNAL.
eThe rhythm does not work when the GENERAL MIDI
mode is set to ON. Turn to GENERAL MIDI status off
to return the instrument to its normal operation.