Building into kitchen benches
These hobs are designed for installation in kitchen benches. When
installed into a corner, the walls or panels above the benchtop
must be at least 155mm away from the edge of the hob to ensure
adequate air circulation to the burners.
The dimensions of each hob and installation openings are shown
in the illustrations included on the following pages.
Insertion and fixing
Before inserting the hob in the installation opening, place the
gasket provided around the bottom edge of the hob. It is important
to fix this gasket evenly, without gaps or overlapping, to prevent
liquid from seeping underneath the hob.
1) Remove the pan supports, burner
heads and caps. Turn the hob upside
down, taking care not to damage the
ignition electrodes and the
thermocouples.
2) Place the gasket around the bottom
edge of the hob as shown in the
illustration on the right.
3) Place the hob in the installation
opening and push it down so that the
hob is resting firmly on the benchtop.
Fit the supplied brackets and screws
as shown in the illustration right.
Tighten the screws to secure the hob
to the benchtop.
Combustible Surfaces
Any adjoining wall surface situated within 200mm from the edge of
any hob burner must be a suitable non-combustible material for a
height of 150mm for the entire length of the hob.
Wall cabinets or extractor hoods must be at least 650 mm above
the hob.
Installation
11
A) Gasket
B) Bracket
C) Screw
A
B
C
To Next Page
Loading...