TechniSat DIGICLOCK 3

8
2.4.1 Setting the correct time
> To set the correct time, switch off the unit by pressing the AL.OFF button (2).
> Then press the TIME SET PRESET button (1) for longer.
> To set the time, press the HOUR / TUN- button (2).
> To set the minutes, please use the MIN / TUN+ button (3).
> To confirm the set time, press the TIME SET PRESET button (1)
.
2.4.2 Automatic tuning
> Switch the radio alarm clock on using the AL.OFF button (2).
> To start the automatic station search, press the HOUR / TUN- (2) or
MIN / TUN+ (3) button longer.
> The radio alarm clock will start automatically searching the band, which will stop
at the first station found.
2.4.3 Manual radio tuning
> To set the correct reception frequency, please use the HOUR / TUN- (2)
and MIN / TUN+ (3)
buttons . Each time they are pressed, the frequency is
changed
by 0.1 MHz.
2.4.4 Save stations to favourites
> To save a station to the favourites list, press the TIME SET PRESET button (1)
longer.
> The programme number will blink on the screen. Using the
HOUR
/ TUN- (2)
or MIN
/ TUN+ (3) buttons, set the desired number and save the programme
by confirming with TIME SET PRESET (1).
2.4.5 Calling a programme from the radio programme list
> Press the TIME SET PRESET button (1) .
> Each successive press changes the number of the favourite programme
one position upwards.
2.4.6 Alarm setting
> To set the alarm, switch off the radio alarm clock by pressing the button
AL.OFF (2) .
> After switching off the device, please press AL.1 / VOL- (8) or AL.2 / VOL+
(9). The time setting will flash on the display.
> You can choose whether you want the device to operate in mode during the
alarm: Radio or Buzzer. The LED with the bell symbol is the option with buzzer.
The LED with the note symbol is the option with radio. Press
AL.1
/ VOL-
button.
(8)
or
AL.2 /VOL+ (9)
to select the desired mode.