96
10.6 Factory seings
If you change the location of the device, e.g. when moving house, it is possible that the
saved stations may no longer be received. In this case you can reset the device to factory
seings to delete all the saved stations and then launch a new scan.
> Open Menu > [Factory seings]
> To perform the factory seings, turn Tune/Select (4) to select [Yes] and press
Tune/Select (4) to confirm.
All previously stored stations and seings will now be deleted. The device is now in
the same status as when delivered.
The display will show [Restart ...] and the device will then start in standby mode.
10.7 Soware version
> Open Menu > [SW version] to display the soware version on the radio.
To Next Page
Loading...