GB 3
Time, 12/24HR and snooze duration setting
1. Press and hold SET, the hour digits flash. Press / to set the hours. Press and hold / will accelerate
your setting.
2. Press SET again, the minute digits flash. Press / to set the minutes. Press and hold / will
accelerate your setting.
3. Press SET again, the display shows “24Hr” flash, press / to select 12Hr 24Hr. In 12Hr mode, P (PM)
LED will appear on the display to indicate afternoon time. There is no AM indicator.
4. Press SET again, the display shows “05” and flashes. Press / to select your snooze time from 5 to 60
minutes.
5. Press SET again or if no key pressed for approx. 10 seconds to exit the setting mode.
Alarms setting
1. TO SET ALARM 1: Press AL 1.2 once, the A1 LED and the hour digits flash. Press / to set the hours of
Alarm 1. Press and hold / to accelerate your setting.
2. Press AL 1.2 once again, the minute digits flash. Press / to set the minutes of alarm 1. Press and hold
/ to accelerate your setting.
3. Press AL 1.2 again, the LED display shows “OFF”. To select the sound sources of your alarm, press / to
select :-
rd = wake-to-radio
bu = wake-to-buzzer
OFF = alarm 1 is off
4. TO SET ALARM 2: Press AL 1.2 again, the A2 LED and the hour digits flash. Press / to set the Alarm
2’s hours. The repeat step 2 to 4 above to set alarm 2.
5. To store your alarm settings, press SET once (or if no button is pressed in around 10 seconds), your clock
radio will return to normal time display mode.
When the related alarm is active, it will be indicated by the appearance of the A1 and / or the A2 LED on the
left side of the display.
Note 1. Press RADIO / SLEEP once to turn on the radio and press / to select a station first for wake-to-radio
alarm.
Note 2: Alarm function only works when your clock radio is powered by AC/DC adaptor.
To stop and reset the alarm to come on the next day
When alarm 1 or 2 is sounding, the related A1 or A2 LED flashes. Press the RADIO / SLEEP or AL 1.2 once to
stop the alarm and reset it to come on the following day. After that A1 and / or A2 LED remains on the display.
Snooze
When alarm is sounding, press once, the alarm will be silenced and repeat after the set snooze duration.
Note: if your second alarm activates while the first alarm is sounding or it is in the snooze mode, the second alarm
overrides the first alarm (the first alarm is reset to come on the next day).
HI-LO-OFF dimmer
Press to select the LED brightness (HIGH / LOW / OFF) of the LED display. This can only be done when
the radio is off.
Set up the FM antenna
Extend the FM wire antenna fully and vary the direction for best FM reception. Do not strip, alter or attach to other
antennas.
FM radio
1. To turn on the radio, press RADIO/SLEEP once, the display shows “ON” and then the radio frequency
readings in Mhz.
2. Press / to tune the radio to a desired station. Press and hold / to scan for the next clear station.
3. To adjust the volume, press VOL once, the display shows “L07” (default volume), press / to adjust
volume from L01 (minimum) to L15 (maximum).
4. Press once to turn off the radio.
Remark: keep your radio away from fluorescent lamps or other electronic devices, which may cause interference to
the radio.
To Next Page
Loading...
Need help?
General
