EN4
Notes
The CO2 sensor will be initialized for about 60 seconds
and then the CO2 values and displays will be updated and
shown.
Place the WL 1025 securely on a flat surface with enough
free space on all sides. This way, the CO2 sensor and the
thermo-hygro sensor within the WL 1025 can get the best
results.
It is recommended to use DC power supply for a long time,
and try not to use the built-in lithium battery to low power.
Time and alarm time setting
In normal display mode, hold the “ ” button for 3
seconds to enter the setting mode.
Press the “+” or the “-” button to adjust the setting and
press the “ ” button to confirm each setting. Keep the “+”
or the “-” button pressed, to accelerate the process and
reach the desired value more quickly.
The setting sequence is shown as follows: 12/24 hour
display -> hour -> minute -> alarm time hour -> alarm time
minute -> °C/°F temperature unit -> exit
Note:
The setting will automatically exit after 30 seconds without
To Next Page
Loading...
