37
the batteries are in place, all segments of the LCD will light up briefly. Following
the time as 0:00 will be displayed. If these are not displayed
after 60 seconds, remove the batteries and wait for at least 30 seconds before
reinserting them.
3. After inserting the batteries, the temperature station will start receiving data from
the transmitter. The outdoor temperature and the signal reception icon should then
be displayed on the temperature station. If this does not happen after 3 minutes,
the batteries will need to be removed from both units and reset from step 1.
4. In order to ensure sufficient 433 MHz transmission however, this should under
good conditions be a distance no more than 100 meters between the final position
of the temperature station and the transmitter (see notes on “Mounting” and “433
MHz Reception”).
5. Once the remote temperature has been received and displayed on the
temperature station, the DCF time (radio controlled time) code reception is
automatically started. This takes typically between 3-5 minutes in good conditions.
To Next Page
Loading...
