21DIY Synth - Manual
Customising your Synth
By this stage you’ll have a fully
functioning Synth but we thoroughly
recommend you keep the creativity
flowing by creating some sort of housing
for it. This will not only make it your
own but also help protect the circuit
and MAKE IT LOUDER if done well.
The examples below are just a very
simple wooden casing with a removable
acrylic lid. But you could make it out of
almost anything...
Whatever you make your casing out of,
a few things to keep in mind are;
You need to be able to get at the battery
to change it.
The speaker works best on a hard
surface and you’ll have to drill a hole
through this to mount it.
The casing needs to have a few holes
for your controls (potentiometers) so
you can actually play it!
Aside from that, go wild! We want to
see some crazy creations!
To Next Page
Loading...