Teckin SP20 - AP Mode Configuration

AP Mode Configuration
1.Make sure AP mode configuration is initiated: the indicator light
blinks blue slowly [once every 3 seconds). If it blinks blue rapidly
(twice per second), press and hold the power button on the Smart
Plug for 6 seconds until the indicator light blinks slowly.
2.Tap the icon “+" at the top right corner of “Smart life” tabb and then
select the device type [Electrical outlet], enter into the ‘Add
Device” page, click "AP Mode” at the top right corner of “‘Add
Device” tab to add device.
T e - L LT 1
o bk fukd Mese AF bkala
Expapar ot Hhe ilsdes el cordim
ihai iredicainr §ghi regeallp Ehnics