Tecknet M008 - Page 5

Move to previous line: Move the selected up to previous line
Copy: Copy the selected contents
Cut: Cut the selected contents
Paste: Pastes the contents copied or cut into the selected location
f. Click "OK" after confirming that the recording is complete
g. Press repeat: when you press and hold, macro is looping till the key is
released
h. Run macro, for instance, set mouse button ⑧ is "macro", press the
mouse button ⑧, you can play the recorded content after the recording is
complete.
20. DPI shift: Switch a 5-speed DPI.
21. Configuration Alt: Switch 5 modes.
22. Lighting switch: Switch 5 lighting effects,( Switch on the bottom button
of the mouse).
23. Disable button: Set buttons non-functional.
24. Mouse pointer acceleration: Adjust pointer speed.
25. Mouse movement speed: Adjust the mouse movement speed.
26. Mouse wheel speed: Adjust the mouse wheel speed.
27. Mouse double-click speed: Adjust mouse double-click speed and test
area.
28. 5 modes: mode1/mode2/mode3/mode4/mode5, 5 modes switch
(Switch is on the underside of the mouse).
29. Mouse rate: choose 125HZ / 250HZ / 500HZ / 1000HZ.
30.
Save configuration: Save configuration content into the computer (save
the file in the format *.PFD).
31. Load configuration: Load an existing document from the computer
settings.
32. Reset: Set the current configuration to the default factory settings.
33. Reset all: Set all configuration to the default factory settings.
34. OK: Run mouse with the above configuration and close the page.
35. Cancel: Cancel the setting and close the page.
36. Apply: Run mouse with the above configuration.
EN