4-209
Verify：Compare Inverter Parameters against Keypad Parameters
16- 09 Selection of keypad removed (LCD)
Range
【0】：Keep operating when LCD keypad is removed
【1】：Display fault when LCD keypad is removed
If 00-02=0, this parameter will decide whether inverter stops after digital operator removed.
Steps LCD Display (English) Description
1
Select the copy function group (16) from the
group menu.
2
Press the Read / Enter key and select parameter
(16-07) copy sel.
3
Press the Read / Enter key to display the data
setting / read screen (LCD display is inversed).
4
Change the set value to 3 (verify) by using the
up arrow key.
5
(1) Use Read / Enter key to enable the read
operation, the display is shown as the left.
(2) The bottom of LCD display will show a bar to
indicate the read progress.
6
-ADV-
VERIFY
COMPLETE
(3) “VERIFY COMPLETE” will be displayed on the
keypad when writing was successful.
(3) The error message of “VRYE Verify Error” may occur on
the keypad when writing parameters to the inverter is
prohibited.
(4) If the error is displayed, press any key to remove the
error message and go back to parameter 16-07.
7
When DSP/FUN key is pressed, the display
returns to parameter 16-07.
To Next Page
Loading...
