TECO F510 series - Page 210

4-121
Range
【0.0~599.0】 Hz
03-45 Frequency Detection Width 2
Range
【0.1~25.5】 Hz
03-46 Frequency Detection Level 3
Range
【0.0~599.0】 Hz
03-47 Frequency Detection Width 3
Range
【0.1~25.5】 Hz
03-50 Frequency Detection Level 4
Range
【0.0~599.0】 Hz
03-51
Frequency Detection Level 5
Range
【0.0~599.0】 Hz
03-52 Frequency Detection Level 6
Range
【0.0~599.0】 Hz
Frequency Detection Level: set the multi-function output terminals R1A-R1C, R2A-R2C or R3A-R3C
(03-11, 03-12 or 03-39) to the output frequency detection signal. Set frequency and output frequency
detection 1 and 2.
The time charts for the Frequency Agree Detection operation are shown in the following Table 4.4.7.
Table 4.4.7 Frequency Detection Operation
Function Detection operation of frequency confirmation Description
Frequency
agree
 Output is active when the output
frequency falls within the
frequency reference minus the
frequency detection width
(03-14).
 Any of the digital outputs function
(03-11, 03-12 or 03-39) can be
set to 2 (Frequency agree).
Set frequency
agree
 Output is active when the output
frequency falls within the
frequency detection width (03-14)
of the set frequency detection
level (03-13).
 Any of the digital outputs function
(03-11, 03-12 or 03-39) can be
set to 3 (Set frequency agree)
Frequency
Deceleration
Detection
time
time
ON
OFF
FWD
REV
03-14
03-14
Freq Reference
Output
Frequency
Frequency
Decelerate
Singal
ON
Freq Reference
OFF
 Signal of frequency deceleration
is ON when output frequency is
out of the range between
frequency reference minus
frequency detection width (03-14)
 Any of the digital outputs function
(03-11, 03-12 or 03-39) can be
set to 58 (Frequency Deceleration
Detection)