TECO TR10 - Step 5: Resetting Chiller Settings

Step 5
Resetting Chiller / Changing the Jumper Settings
Plug in and turn on the chiller
At the top of the control panel, above the display and
controls are a series of small metal prongs. Remove the
plastic “jumper” from prongs 4 and 5.
Place jumper on pins 7&8, this will reset your chiller.
Remove jumper from pins 7&8.
Now turn off your chiller.
CAUTION: Leaving chiller on with no water flowing will cause
the unit to overheat.
Place Jumper over pins 5&6 (see diagram below)
Note: Resetting your chiller will change your set
temperature to the default of 23°C.
Before Installation Settings Required to operate the Heater
UV Jumper
(Position may vary
depending on whether
UV is installed)
Heater Jumper
(Position may vary
depending on whether
heater is installed)
Reset Pins
(Place jumper here momentarily to reset)
7
7
1
2
3
1
2
3
4
5
6
4
5
6
8
8
Front
of
Chiller
Front
of
Chiller