Before connecting your DualTeddyCap
The TeddyCap power supply family was designed
to power Naim Audio pre amplifiers, CD players,
headphone amplifiers, active crossovers, phono
stages, etc. They replace the original products:
HiCap, FlatCap, SuperCap and XPS.
Please follow your Naim Audio product owner’s manual
for the corresponding connection diagram.
Note that according to the Naim Audio schema, power
amplifiers should be connected to the power supply
rather than to the pre amplifier. Failing to do so may
damage the power supply and/or the power amplifier.
Mains Power
The power supply should be connected to the mains
via a standard cable with an IEC plug. For safety
reasons it is preferable to use cables with molded
plugs. The power supply should be connected to a
grounded mains socket.
Fuses
The power supply is equipped with a fuse that
resides in a small drawer on the IEC socket situated
on the rear panel. Use only “slow blow” fuse for
replacement.
We are not great fans of "Audiophile Fuses".
Nevertheless, if you plan on using them, you should
consider 30% higher rating
Use the following table to select the appropriate
fuse value:
Power supply
220-240V 110-120V
TeddyCap
315-400mA 680-1000mA
TeddyCapPlus
315-400mA 680-1000mA
DualTeddyCap
400-680mA 800-1000mA
TeddyXPS
800-1000mA 1600-2000mA
TeddySuperCap
400-680mA 800-1000mA
To Next Page