E- CLEANING, MAINTENANCE AND TRANSPORTATION OF YOUR
PRODUCT
23
CAUTION!
Unplug your product before every cleaning.
Always wear protective gloves during cleaning and maintenance. This will protect you from injuries.
Never use domestic cleaning agents, abrasive and scratching substances (surface cleaners, detergent,
may occur in the plastic parts of your product.
CLEANING
Following warnings must certainly be abided before start cleaning.
Before the internal cleaning, wait until the temperatures of the internal parts of your product reaches to
the ambient temperature.
Always wear protective gloves during cleaning and maintenance. This will protect you from injuries.
Remove the accessories from inside.
Perform cleaning with a soft cotton cloth and warm soapy water or by using the cleaning agents recom-
mended by Tefcold.
Dry with a dry cotton cloth. Products, which are not dried, may darken in time.
Make sure that no wet or humid area is left in the internal section after cleaning.
You can reload your product three (3) hours after running your product as stated in this manual.
Clean with a cotton cloth and warm soapy water.
Prevent penetration of cleaning water into the front control panel and lighting section while cleaning.
Clean the door gasket by using clean soapy water only.
This product does not require periodical maintenance.
To Next Page
Loading...
