Operation
The following instructions assume Model 252 and Model 1412B are connected and both are
turned on.
Model 252 setup: (for capacitor sorting)
1. Push the C button on the Model 252 front panel.
2. Set the range switch to give maximum resolution on the display.
Model 1412B setup:
1. Set the rear panel V REF switch to INTERNAL.
2. Set NOMINAL VALUE switches to anticipated value.
3. Set LIMITS FULL SCALE toggle switches, and % LIMITS and D
LIMIT dials to desired limits.
The measurement:
Connect unknown to the Model 252. If the unknown is within the set limits, the GO LED
will light. If it is not within limits, the appropriate indicator will light.
2-30
To Next Page
Loading...
