Section
7
-
2225
Service
OPTIONS AND ACCESSORIES
INTRODUCTION
This section lists the standard accessories (including
Tektronix part numbers) that are shipped with each
insturment. It also briefly describes the options that
can be included with the original instrument order.
If
you wish to obtain any of these options after receibing
your insturment, use the accessories lists contained
in Tables 7-1 and 7-2. For additional information
about instrument options and other optional accesso-
ries, consult the current Tektronix Product Catalog or
contact your local Tektronix Field Office or distributor.
STANDARD ACCESSORIES
The following standard accessories are provided with
each instrument:
Qty Description Part Number
1 Power Cord and Fuse Per option
ordered;
see Table 7-1
1 Operator's Manual 070-6298-01
1 Power-cord Clamp 343-0003-00
1 Washer 2 1 0-0803-00
1
Self-Tapping Screw 213-0882-00
2
Probes,lOX, 2 m, P6103
with accessories
OPTIONS
sites. It includes a protective front-panel cover and
an accessories pouch that attaches to the top of the
instrument.
Option
1C
An oscilloscope camera is useful for capturing signle
events and documenting measurement results. And
it helps communicate results with clrity and credibili-
ty. Option
1
C provides the Tektronix C-5C Option 04
Low-cost Camera for use with your oscilloscope.
Option
1K
When this option is specified, a K212 Portable Instru-
ment Carty is included in the shipment. The cart pro-
vides a stable yet movable platform that is well suited
for on-site instrument mobility in a variety of work ar-
eas.
Option
1
R
When the oscilloscope is ordered with Option 1
R,
it is
shipped in a configuration that permits easy installa-
tion into virtually any 1 9-inch-wide, electronic-equip-
ment rack. All hardware is supplied for mounting the
instrument into the rack.
Complete rackmounting instructions are provided in a
separate document. These instructions also contain
the procedures for converting a standard instrument
into the Option 1
R
configuration by using the sepa-
rately ordered rackmounting conversion kit.
Option
02
Option
23
This option is intended for users who need added Two P6119 IX-1OX Selectable-attenuation Probes
front-panel protection and accessories-carrying are provided in place of the standard
P6103 10X
ease demanded by frequent travel to remote service
Probes.
REV
APR
1990
Scam
by
ARTEK
MEDU
=>
To Next Page
Loading...